14.5.1.1.5 Complex I/O Modules; Table 239: Fault Cases Of Complex I/O Modules With Diagnostics Capability - WAGO -I/O-SYSTEM 750 Manual

210 Appendix

14.5.1.1.5 Complex I/O Modules

Table 239: Fault cases of complex I/O modules with diagnostics capability

Item
number
750-606 BIT
750-610,
750-611
75x-630 DWORD 0x0016 / 22
75x-635 OTHER 0x0009 / 9
75x-636 OTHER 0x0009 / 9
75x-637 OTHER 0x00011 / 17 Sensor or load
75x-641 OTHER 0x0009 / 9
75x-642,
75x-650,
75x-651,
75x-652
75x-653
75x-643 OTHER 0x0009 / 9
75x-644 OTHER 0x0009 / 9
75x-645 OTHER 0x0009 / 9
75x-655 OTHER 0x00011 /172
75x-670
75x-671
75x-672
75x-673
Data Error type
format
0x0002 / 2
0x0011 / 17
0x001A / 26
BIT 0x0011 / 17
0x0012 / 18
0x001A / 26
0x001A / 26
OTHER 0x0007 / 7
0x001A / 26
0x0009 / 9
0x001D / 29
OTHER 0x0009 / 9
750-375 PROFINET IO advanced Fieldbus Coupler
Explanation
Sensor or load Output voltage too low
voltage missing Field voltage not present or too low
External fault Output voltage short circuit
Sensor or load Field voltage too low or not present
voltage missing
Fuse defective Fuse defective or not present
Sampling error An incorrect data frame exists, i.e. the
data frame is not terminated with zero
(possible wire break of clock lines).
External fault SSI has no power supply or data line
break, or D+ and D- have been inverted.
Error Wave speed not set
or
inadequate stop pulses
or
the maximum wave speed exceeded
or
timeout, no measurement values exist,
measurement value invalid
or
error when setting the wave speed or zero
point has occurred
or
invalid transmitter selection, the selected
transmitter address is invalid because of
the missing initialization
Error Status/error message.
Loss of field power
voltage missing
Error General module error, e.g. POST of the
internal flash memory,
External fault DALI bus error (continuous short circuit
or open circuit), but no faulty electronic
ballasts.
Upper limit value The receiver buffer is completely full,
exceeded there is a danger of loss of data
Error Internal error (e.g. hardware error)
Error Non-existent or invalid process data
Error Internal error, e.g. hardware defect
External fault External error (line break or short circuit)
Sensor or load Field power and/or AS-I supply faulty
voltage missing
Error Field power and/or AS-I supply faulty
and AS interface master inactive
Bus communica- AS interface master inactive
tion faulty
Error Error present.
WAGO-I/O-SYSTEM 750
Manual
Version 1.1.0