Figure 47: Ipar Server; Table 38: Legend For The Ipar Server Figure - WAGO -I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-375 PROFINET IO advanced Fieldbus Coupler

Figure 47: iPar Server

Table 38: Legend for the iPar server figure

No. Explanation
1 Instantiation of the "iPar Server" function
2 CDP Tool Start and parameter transfer (e.g., node address)
3 iParameterization and start-up, test and release
4 Transfer of iParameter backup (signature) to the host
5 During start-up, transfer of the signature to F-slave (Prm_Telegram)
6 Message to iPar server about diagnostic agent (alarm/status)
7 iPar server polls the diagnostic function block (Diag-FB) and starts "Save" if
required
8 iPar server polls the diagnostic function block (Diag-FB) and starts
"Restore" if required
The WAGO parameterization tool WAGO-SEDI is used for fail-safe
parameterization and can be executed from the configuration environment of the
IOCs used. To call up SEDI, three different communication paths are available
that correspond to the TCI conformance classes:
1 Local configuration interface (TCI CC1)
The SEDI is called up via WAGO-I/O-CHECK.
2 TCP/IP communication via WAGO service port 6626 (TCI CC2)
The SEDI is called up via WAGO-I/O-CHECK.
Manual
Version 1.1.0
Function Description 91