WAGO-I/O-SYSTEM 750
750-375 PROFINET IO advanced Fieldbus Coupler
Figure 6: System voltage for standard couplers/controllers and extended ECO couplers
Pos : 19.13.10 /Seri e 750 ( WAGO-I/O-SYSTEM)/Systembes chr eibung/Versorgung/Systemvers orgung - Ansc hlus s - Hi nweis : Gl eichz. R üc ks etzen aller Vers orgungsmodul e @ 3\mod_1232950097906_21.doc x @ 26760 @ @ 1
Only reset the system simultaneously for all supply modules!
Reset the system by simultaneously switching the system supply at all supply
modules (fieldbus coupler/controller and potential supply module with bus power
supply) off and on again.
Pos : 19.13.11 /Seri e 750 ( WAGO-I/O-SYSTEM)/Systembes chr eibung/Versorgung/Systemvers orgung - Ausl egung @ 3\mod_1232950104812_21.doc x @ 26780 @ 4 @ 1
3.6.2.2
Dimensioning
Recommendation
A stable power supply cannot always be assumed. Therefore, you should use
regulated power supplies to ensure the quality of the supply voltage.
The supply capacity of the fieldbus coupler/controller or the internal system
supply module can be taken from the technical data of the components.
Table 5: Alignment
Internal current
consumption
Total current
for I/O modules
*)
See current catalog, manuals, Internet
Pos : 19.13.12 /D okumentation allgemein/Gliederungselemente/---Sei tenwechsel--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 1.1.0
Current consumption via system voltage (5 V for electronics
*)
of I/O modules and fieldbus coupler/controller).
Available current for the I/O modules. Provided by the bus
*)
power supply unit. See fieldbus coupler/controller and
internal system supply module
System Description
25