Water Pump Belt - Suzuki RA410 Manual

6B-10 ENGINE COOLING
2
INSTALLATION
3
1) When positioning thermostat (1) on thermostat case (2), be
sure to position it so that air bleed valve (3) comes at position
as shown in figure.
2) Install thermostat cap to thermostat case.
3) Connect cooling water hose.
4) Fill cooling system (refer to page 6B-6, 6B-7).
5) Install air cleaner case.
6) Connect negative cable at battery.
7) After installation, check each part for leakage.

WATER PUMP BELT

REMOVAL
1) Disconnect negative cable at battery.
2) Loosen drive belt adjusting bolt (2) and generator pivot bolts (3).
When servicing car equipped with A/C, remove compressor
drive belt before removing water pump belt (1).
4) Slacken belt by displacing generator and then remove it.
INSTALLATION
1) Install belt to water pump pulley, crankshaft pulley and genera-
tor pulley.
When servicing car equipped with A/C, install compressor drive
belt, too.
2) Adjust belt tension.
For Adjustment of compressor drive belt tension, refer to SEC-
TION 0B of this manual.
3) Tighten water pump belt adjusting bolt and pivot bolts.
4) Connect negative cable at battery.
WATER PUMP BELT TENSION INSPECTION AND AD-
JUSTMENT
For this inspection or adjustment, refer to WATER PUMP BELT
TENSION.