LUBRICATION
When inner parts of the steering gear case were disas-
sembled, they should be washed clean before reas-
sembly. It is recommended to use the grease as given
at the right where grease application is indicated in the
text.
TIE ROD END BOOT CHECK
Inspect each boot for tear. If even a small tear is noted, replace with
new one.
STEERING SHAFT JOINT CHECK
Check shaft joint for wear, breakage and other damage and re-
place if any defect exists.
TIE ROD END CHECK
Inspect for play in ball joint.
Inspect for play in rack end ball joint.
In either case, if found defective, replace.
ON-VEHICLE SERVICE
MANUAL RACK AND PINION 3B-3
SUZUKI SUPER GREASE E (99000-25050) or
Lithium grease (applicable for –40 C ~ 130 C
(–40 F ~ 266 F))