Suzuki RA410 Manual page 229

3
2
1
"A"
9) Install wheel and tighten wheel nuts to specified torque.
Tightening torque for wheel nut
85 N·m (8.5 kg-m, 61.5 lb-ft)
10) Check to ensure that brake drum is free from dragging and
proper braking is obtained. Then remove vehicle from hoist
and perform brake test (foot brake and parking brake).
11) Check each installed part for oil leakage.
BRAKE BACK PLATE
REMOVAL
1) Remove brake drum, refer to BRAKE DRUM REMOVAL.
2) Remove brake shoe, refer to BRAKE SHOE REMOVAL.
3) Remove wheel cylinder, refer to WHEEL CYLINDER RE-
MOVAL.
4) Remove parking brake cable securing clip (1) and disconnect
brake cable (2) from brake back plate.
5) Remove brake back plate (1) by removing bolts (2).
INSTALLATION
1) Apply water tight sealant to mating surfaces of brake back plate
and rear axle.
"A": Sealant 99000-31090
2) Install brake back plate and tighten back plate bolts to specified
torque.
Tightening Torque
(a): 23 N·m (2.3 kg-m, 17.0 lb-ft)
BRAKES 5-25