Piston, Piston Rings, Connecting Rods - Suzuki RA410 Manual

6A4-54 ENGINE MECHANICAL
8
7
1. Top ring:
: Apply engine oil.
2. 2nd ring:
: Apply engine oil.
3. Oil ring:
: Apply engine oil.
4. Piston:
: Apply engine oil.
5. Connecting rod:
: Apply engine oil
except inner surface
of big end.
1
1
2
3
4
5
6
10 33 N·m (3.3 kg-m)
6. Connecting rod
bearing cap:
: Apply engine oil
except inner surface
of big end.
7. Connecting rod
bearing:
: Apply engine oil
to inner surface.
8. Piston pin:
: Apply engine oil.
9. Piston pin circlip
10. Bearing cap nut:
: Tightening Torque
PISTON, PISTON RINGS, CONNECTING
RODS
REMOVAL
1) Remove cylinder head from cylinder block as previously out-
lined.
2) Drain engine oil.
3) Remove oil pan and oil pump strainer as previously outlined.
4) Mark cylinder number on all pistons, connecting rods and rod
bearing caps, using silver pencil or quick drying paint.
5) Remove rod bearing caps.
6) Install guide hose (1) over threads of rod bolts. This is to prevent
damage to bearing journal and rod bolt threads when removing
connecting rod.
7) Decarbon top of cylinder bore before removing piston from cyl-
inder.
8) Push piston and connecting rod assembly out through the top
of cylinder bore.