Suzuki RA410 Manual page 448

STEP
7 Ignition Coil Power Supply And Ground Circuit Check
1) Check ignition coil power supply ("BW" wire) circuit
for open and short.
Are circuits in good condition?
8 Ignition Coil Check
1) Check ignition coil for resistance, referring to "Igni-
tion Coil" in this section.
Is check result satisfactory?
9 CMP Sensor Check
1) Check CMP sensor and signal rotor, referring to
"Distributor" in this section.
Is check result satisfactory?
10 Ignition Trigger Signal Circuit Check
1) Check ignition trigger signal ("Y/R" wire) circuit for
open, short and poor connection.
Are circuits in good condition?
11 Ignition Timing Check
1) Check initial ignition timing and ignition timing ad-
vance, referring to "Ignition Timing" in this section.
Is check result satisfactory?
12 Ignition Timing Adjustment And Recheck
1) Adjust initial ignition timing, referring to "Ignition
Timing" in this section.
2) Recheck initial ignition timing and ignition timing
advance, referring to "Ignition Timing" in this sec-
tion.
Is check result satisfactory?
ACTION YES
Go to Step 8.
Go to Step 9.
Go to Step 10 on the
next page.
Go to Step 11.
Substitute a known-
good ECM (or PCM)
and then repeat STEP
2.
System is in good
condition.
IGNITION SYSTEM 6F1-5
NO
Repair or replace.
Replace ignition coil
assembly.
Adjust or replace.
Repair or replace.
Go to Step 12.
Substitute a known-
good ECM (or PCM)
and then repeat STEP
2.