Heater Control Lever Assembly - Suzuki RA410 Manual

2
3
INSPECTION
Measure each terminal-to-terminal resistance on resistor
Resistance
If measured resistance is incorrect, replace blower motor resistor.
INSTALLATION
1) Reverse removal procedure for installation.
2) Enable air bag system, if equipped.

HEATER CONTROL LEVER ASSEMBLY

1
REMOVAL
1) Disconnect negative (–) cable at battery.
2) Disable air bag system, if equipped.
3) Remove meter cluster hood, ashtray, center garnish, instru-
4) Disconnect each heater control cables (mode (1), temperature
5) Disconnect blower fan switch coupler and A/C switch coupler
6) Remove heater control lever assembly (3).
7) Remove blower fan switch. Refer to BLOWER FAN SWITCH in
Me – Lo : 1.5–3.0 at 25 C (77 F)
Me – Hi : 0.5–1.5 at 25 C (77 F)
Refer to ENABLING AIR BAG SYSTEM in Section 10B.
Refer to DISABLING AIR BAG SYSTEM in Section 10B.
ment glove box and radio or accessory case (if equipped).
(2) and fresh air control).
(if equipped).
this section.
HEATER AND VENTILATION 1A-7