Suzuki RA410 Manual page 508

2
1
3
(A)
(C)
2
SUB ASSEMBLY SERVICE
NOTE:
Before installation, wash each dart and apply specified gear
oil to sliding faces of bearing and gear.
Use new circlips on shaft for installation. Don't reuse cir-
clips.
RIGHT CASE
DISASSEMBLY
1) Remove bolt and then pull out vehicle speed sensor (1) from
right case (2).
2) Remove counter oil gutter plate (1) from right case (2).
3) Remove differential gear assembly (3) from right case.
2
4) Remove input shaft oil seal (1) using special tools (combination
of bearing remover and sliding shaft).
Special Tool
(A): 09930-30102
(A)
(B): 09923-74510
5) Also pull out countershaft right bearing cup (2) using special
tools.
(B)
Special Tool
(A): 09930-30102
1
(C): 09941-64511
NOTE:
If input shaft right bearing has been left in right case, pull
it out by using bearing remover 09923-74510 with sliding
shaft 09930-30102.
6) Remove differential side right oil seal using screw driver.
MANUAL TRANSMISSION 7A-15