Power Window Control System (If Equipped) - Suzuki RA410 Manual

A
C
1
2
3
4 5
G H C K I
A B E F
REAR WASHER PUMP
INSPECTION
Refer to FRONT WIPER AND WASHER INSPECTION in this sec-
tion.
REAR WIPER MOTOR
INSPECTION
1) TESTING WIPER MOTOR
As shown left, use a 12V battery to connect its ( + ) and (–) termi-
nals to terminal "B" and terminal "A" respectively. Then motor
should rotate at 35 to 45 rpm.
2) TESTING AUTOMATIC STOP ACTION
a) First, connect battery (+) terminal to terminal "B" and battery
(–) terminal to terminal "A" and let the motor turn.
b) Then disconnect terminal "B" from battery and let the motor
stop.
B
c) Next connect terminal "B" and terminal "C" with a jumper wire
D
and connect terminal "D" to battery (+) terminal. Observe the
wiper motor turns once again, then stops at a given position.
d) Repeat these steps several times, and inspect if the motor
stops at the given position every time.
POWER WINDOW CONTROL SYSTEM (IF
EQUIPPED)
POWER WINDOW MAIN SWITCH
INSPECTION
Inspect switch continuity between terminals.
Window
Lock Switch
(1) (1)
Switch
J
OFF
ON
Passenger
Driver Side
Window
Window
Switch (2)
Switch (3)
Terminal
K C A B K C E F K C G H K C I
UP
OFF
DOWN
UP
OFF
DOWN
BODY ELECTRICAL SYSTEM 8-25
Rear LH Rear RH
Side
Window Window
Switch (4) Switch (5)
J