Drive Belt Inspection (G10 Engine); A/C Compressor Drive Belt Inspection (If Equipped); Water Pump Belt Inspection; Drive Belt Replacement (G10 Engine) - Suzuki WagonR+ RB310 Service Manual

Drive Belt Inspection (G10 Engine)

WARNING:
Disconnect negative cable at battery before checking and
replacing belt.

A/C compressor drive belt inspection (If equipped)

1) Hoist vehicle and remove engine under cover of right side
from vehicle body.
2) Inspect belt for wear, deterioration and tension.
Replace or adjust, if necessary.
A/C compressor drive belt tension "a":
7 – 9 mm (0.28 – 0.35 in.) deflection under 100 N, 10 kg or
22 lb pressure
1. A/C compressor pulley
2. Blank
3. Tension pulley
4. Crankshaft pulley

Water pump belt inspection

1) Inspect belt for cracks, cuts, deformation, wear and cleanli-
ness.
Replace, if necessary.
2) Check pump belt for tension and adjust it as necessary.
Water pump belt tension "a":
7 – 9 mm (0.27 – 0.35 in.) deflection under 100 N, 10 kg or
22 lb pressure

Drive Belt Replacement (G10 Engine)

A/C compressor drive belt replacement

1) Disconnect negative cable from battery.
2) Remove engine under cover of right side.
3) Loosen belt tension and replace belt with new one.
4) Adjust belt tension to specification.
5) Install engine under cover and connect negative cable to bat-
tery.

Water pump belt replacement

Replace belt with a new one. Refer to Section 6B for replacement
procedure of pump belt.
NOTE:
When replacing belt with a new one, adjust belt tension
to 6 – 7 mm (0.24 – 0.27 in.).
MAINTENANCE AND LUBRICATION 0B-9