On-Vehicle Service; Drive Shaft Assembly - Suzuki RA410 Manual

4A-4 FRONT DRIVE SHAFT
A: Undo caulking
3
4 2
1
2
1
2
3

ON-VEHICLE SERVICE

DRIVE SHAFT ASSEMBLY

REMOVAL
1) Undo caulking and remove drive shaft nut (1) and washer.
2) Hoist vehicle.
3) Remove wheel.
4) Remove tie-rod end split pin (1) and castle nut (2).
5) Disconnect tie-rod end (3) from steering knuckle (4) by using
6) Drain transmission fluid.
7) By using large size lever (1), pull out drive shaft joint (2) so as
8) Disconnect front suspension control arm ball stud (1) from
4
1
9) Remove drive shaft assembly.
special tool.
Special Tool
(A): 09913-65210
to release snap ring fitting of joint spline at differential side.
steering knuckle (2) by pushing down stabilizer bar (4) after re-
moving ball stud bolt (3).
CAUTION:
To prevent breakage of boots, be careful not to bring
them into contact with other parts, when removing
drive shaft assembly.