Steering Wheel - Suzuki RA410 Manual

b)
a)
a)
d)
c)
1, (a)
For vehicle without air bag system
1
2
INSTALLATION
1) Check that horn wire is connected to horn connector (2) secure-
ly.
2) Connect yellow connector (1) of driver air bag (inflator) module
(3) and horn connector in order a)–d) shown in the figure se-
curely.
3) Install driver air bag (inflator) module to steering wheel, taking
care so that no part of wire harness is caught between them.
4) Make sure that clearance between module and steering wheel
is uniform all the way.
5) Tighten driver air bag (inflator) module mounting bolts (1) to
specified torque.
Tightening Torque
(a): 9 N·m (0.9 kg-m, 6.5 lb-ft)
6) Connect negative cable at battery.
7) Enable air bag system. Refer to ENABLING AIR BAG SYSTEM
1, (a)
under SERVICE PRECAUTIONS in SECTION 10B.

STEERING WHEEL

CAUTION:
For vehicle with air bag system:
Removal of the steering wheel allows the contact coil to
turn freely but do not turn the contact coil (on the com-
bination switch) more than allowable number of turns
(about two and a half turns from the center position
clockwise or counterclockwise respectively), or coil will
break.
REMOVAL
1) For vehicle without air bag system:
3
a) Disconnect negative cable at battery.
b) Remove steering wheel pad screw (3).
c) Remove steering wheel pad (1).
d) Disconnect horn connector (2).
STEERING WHEEL AND COLUMN 3C-5