Suzuki RA410 Manual page 682

9-40 BODY SERVICE
1
1
"A"
2
2
4
3
2
3
1
1
3
4
"a"
SECURITY AND LOCKS
FRONT DOOR LOCK ASSEMBLY
REMOVAL
1) Raise window all the way up.
2) Remove door trim and door sealing cover, refer to step 1) to 7)
of FRONT DOOR GLASS REMOVAL in this section.
3) Remove door opening control rod (1).
4) Remove door lock control rod (2).
5) Disconnect push lever (3).
6) Disconnect key cylinder rod (4).
7) Remove lock assembly.
INSTALLATION
To install front door lock, reverse removal procedure, noting the fol-
lowings points.
Door latch striker.
Move door latch striker (1) up or down so its center aligns with
the center of groove "A" on the door, as shown.
NOTE:
Striker (1) should be moved vertically and placed level. Do
not adjust door lock (2).
Move door latch striker (1) sideways to adjust door surface (2)
flush with body surface (3), as shown.
In order to correctly obtain door latch (1) position in the fore-and-
aft direction, increase or decrease number of shims (4) inserted
between body (3) and striker (1) to adjust it.
Dimension "a": 12.0 – 14.0 mm (0.47 – 0.55 in.)
NOTE:
Apply oil or grease to striker joints periodically.