Suzuki RA410 Manual page 166

3D-18 FRONT SUSPENSION
1, (a)
(a)
INSTALLATION
For installation, reverse removal procedure, observing following
instructions.
1) Install body side of suspension control arm but tighten suspen-
sion control arm bolt (1) only temporarily.
1
2) Install suspension control arm ball joint to steering knuckle.
Align ball stud groove with steering knuckle bolt hole. Then
install ball joint bolt (1) from the direction as shown.
Tightening Torque
(a): 60 N·m (6.0 kg-m, 43.5 lb-ft)
3) Install wheel and tighten wheel nuts to specified torque.
Tightening Torque
(a): 85 N·m (8.5 kg-m, 61.5 lb-ft)
4) Lower hoist and vehicle in non-loaded condition, tighten control
arm bolt (1) to specified torque.
Tightening Torque
(a): 60 N·m (6.0 kg-m, 43.5 lb-ft)
1, (a)
Install stabilizer bar, referring to STABILIZER BAR AND/OR
BUSHINGS in this section.
Confirm front end (wheel) alignment referring to Section 3A
FRONT END ALIGNMENT.