Suzuki RA410 Manual page 174

1
Upper side
1
3
2
LARGE
1
2
FORWARD
2
1
3
6) Remove shock absorber lower nut (1).
7) Detach shock absorber lower side from rear axle.
8) Lower rear axle (1) gradually as far down as where coil spring
2
9) Remove coil spring.
1
INSTALLATION
1) Install coil spring (1) with its small pitch end facing up and large
SMALL
2) Install shock absorber (1) lower side to rear axle.
3) Remove floor jack from rear axle.
4) Install brake flexible hose E-ring.
5) Install lateral rod (1) right side to vehicle body, refer to figure for
2
6) Remove floor jack from rear axle.
3
1
(2) can be removed.
CAUTION:
Be careful not to let rear axle down too much.
It may cause damage to brake flexible hose.
pitch end (with paint marking) down and make sure that spring
end contact to stepped part (2) of spring seat (3) as shown.
Tighten shock absorber lower nut (2) temporaliry at this step.
proper installing direction of bolt (2).
Tighten nut (3) temporaliry at this step.
REAR SUSPENSION 3E-7