Suzuki RA410 Manual page 235

(A)
2
3
1
2
3
4) Remove sleeve (1) from sleeve cup.
Special Tool
(A): 09900-06106
NOTE:
Do not cause any damage to inside of sleve.
If caused, replace primary piston assembly.
5) Install sleeve cup (3) and O-ring (2) to sleeve (1) such a direc-
tion as shown.
NOTE:
Diameter of sleeve cup and O-ring are smaller than those
of cap.
O-ring is the same as that of smaller one of cap O-ring.
1
6) Install sleeve assembly with aligning protrusion (1) of sleeve
and dent (2) of cylinder body.
2
7) Install cup (1) and washer (2) such a direction as shown.
NOTE:
Primary cup is the same as secondary cup.
Primary cup is the largest compared with that of cap and
sleeve.
2
1
8) Remove cap cup (1) from cap with caring not to cause any dam-
1
age to inside of cap (2).
9) Install cap cup and O-rings (3) to cap such a direction as shown.
BRAKES 5-31