Suzuki RA410 Manual page 582

OUTPUT SHAFT
3
DISASSEMBLY
1) Remove seal ring.
2) Using press (1), remove output shaft from reduction gear (2).
3) Remove snap ring (1) and then pull off bearing (2) toward the
ASSEMBLY
Assemble parts in reverse order of disassembly, noting following
points.
1
Apply A/T fluid to press-fit surface.
Install reduction drive gear (1) to output shaft (2).
Be sure to match splines before press-fitting.
Press-fit reduction drive gear (1) till bearing (3) contacts snap ring
(4).
4
2
front.
AUTOMATIC TRANSMISSION 7B-55
1. Output shaft
2. Reduction drive gear
3. Seal ring
4. Snap ring
5. Bearing
6. Shim