Receiver/Driver - Suzuki RA410 Manual

1B-14 AIR CONDITIONING (OPTIONAL)
2
"a"
1
1
"b"
2
INSPECTION
Check the following.
Clogged condenser fins should be washed with water, and should
be dried with compressed air.
NOTE:
Be careful not to damage condenser fins. If condenser fin is
bent, straighten it by using a screwdriver or pair of pliers. If
any leakage is found from fitting or tube, repair or replace con-
denser.
RECEIVER/DRYER
(1) REMOVAL
1) Recover refrigerant from refrigeration system by using recovery
2
2) Disconnect receiver outlet hose (1) and condenser outlet pipe
3
3) Loosen receiver/dryer bracket bolt (4).
4
4) Remove receiver/dryer with its bracket.
INSTALLATION
Reverse removal sequence to install receiver/dryer noting the fol-
lowing points.
Condenser fins for leakage, blockage and damage
Condenser fittings for leakage
and recycling equipment.
(2) from receiver/dryer (3).
If receiver/dryer (1) is replaced, pour 20 cc of refrigerating oil to
compressor suction-side.
Evacuate and charge system according to previously described
procedure.
Install receiver/dryer (1) to its bracket (2) as shown in figure.
"a" 35
"b" 58 – 59 mm (2.28 – 2.32 ln)