Radiator (And Condenser) Cooling Fan Relay; Compressor - Suzuki RA410 Manual

2
b
a
c
a
c
d
2. Radiator (and condenser) cooling fan fuse
1
2
3
RADIATOR (AND CONDENSER) COOLING
1
FAN RELAY
INSPECTION
1) Disconnect negative (–) cable at battery.
2) Remove radiator cooling fan relay (1) from vehicle.
3) Connect battery positive (+) terminal to terminal "b" of relay.
1
d
b

COMPRESSOR

REMOVAL
1) RUN engine at idle speed with air conditioning ON for 10 min-
2) Disconnect negatige (–) cable at battery.
3) Recover refrigerant from refrigeration system by using recovery
4) Remove front bumper.
5) Disconnect magnet clutch lead wire (1) and undo lead wire
6) Disconnect suction and discharge hoses from compressor.
7) Remove compressor drive belt by loosening compressor bolt.
8) Remove compressor with magnet clutch assembly (3) from its
9) If compressor is replaced.
INSTALLATION
Reverse removal procedure noting the following point.
1. New compressor
2. Removed
compressor
3. Excess oil (A–B)
Connect battery negative (–) terminal "a" of relay.
Check continuity between terminal "c" and "d".
If there is no continuity when relay is connected to the battery,
replace relay.
utes. After that stop the engine.
and recycling equipment.
clamp (2).
NOTE
Cap open fittings immediately to keep moisture out of sys-
tem.
mount as shown.
Drain oil from compressor, and measure its amount.
If compressor is replaced, pour new compressor oil with the
same amount as that drained from compressor in REMOVAL.
Refer to "REPLENISHING COMPRESSOR OIL" in this section.
Evacuate and charge system according to previously described
procedure.
AIR CONDITIONING (OPTIONAL) 1B-19