Suzuki RA410 Manual page 488

(a)
2
(c)
2
10) Install rectifier holder (1).
(b)
(a)
1
11) Install brush holder cover (1) to brush holder (2).
1
12) Place the IC regulator (1) together with the brush holder (2)
13) Install the 5 screws until there is a clearance of approx. 1 mm
14) Install rear end cover (1).
(d)
3
(e)
15) Install insulator (2) and tighten B terminal inner nut (3) to speci-
1
2
16) Make sure that rotor turns smoothly.
CAUTION:
When installing rectifier, check to confirm that stator
leads have enough clearance with cooling fan
blades.
Tightening Torque
.
(a): 2.0 N m (0.2 kg-m, 1.5 lb-ft)
.
(b): 2.3 N m (0.23 kg-m, 1.7 lb-ft)
horizontally on the rear end frame (3).
(0.04 in.) between the brush holder and connector.
Tightening Torque
.
(c): 2.0 N m (0.2 kg-m, 1.5 lb-ft)
Tightening Torque
.
(d): 4.5 N m (0.45 kg-m, 3.5 lb-ft)
fied torque.
Tightening Torque
.
(e): 4.2 N m (0.42 kg-m, 3.0 lb-ft)
CHARGING SYSTEM 6H-19