Suzuki RA410 Manual page 8

WARNING:
SDM
WARNING:
Driver and Passenger Seat Belt Pretensioners
(If equipped)
1
For handling and storage of a SDM, select a place
where the ambient temperature below 65 C (150 F),
without high humidity and away from electric noise.
During service procedures, be very careful when han-
dling a Sensing and Diagnostic Module (SDM). Never
strike or jar the SDM.
Never power up the air bag system when the SDM is
not rigidly attached to the vehicle. All SDM and mount-
ing bracket fasteners must be carefully torqued and
the arrow must be pointing toward the front of the ve-
hicle to ensure proper operation of the air bag system.
The SDM could be activated when powered while not
rigidly attached to the vehicle which could cause de-
ployment and result in personal injury.
For handling and storage of a live seat belt pretension-
er, select a place where the ambient temperature be-
low 65 C (150 F), without high humidity and away from
electric noise.
Never carry seat belt pretensioner by wire or connec-
tor of pretensioner. When placing a live seat belt pre-
tensioner on the workbench or some place like that, be
sure not to lay it with its exhaust hole (1) provided side
facing down. It is also prohibited to put something on
its face with an exhaust hole or to put a seat belt pre-
tensioner on top of another. Otherwise, personal inju-
ry may result.
Never dispose of live (inactivated) seat belt preten-
sioners (driver and passenger). If disposal is neces-
sary, be sure to activate them according to activation
procedures described in SECTION 10B before dispos-
al.
The seat belt pretensioner immediately after activation
is very hot. Wait for at least half an hour to cool it off
before proceeding the work.
With many service procedures, gloves and safety
glasses should be worn to prevent any possible irrita-
tion of the skin or eyes.
GENERAL INFORMATION 0A-5