Suzuki RA410 Manual page 138

2
3
**1
*1
1
3) Remove steering column cover screws (3 pcs) (1).
4) Loosen steering column mounting nuts. Refer to STEERING
5) Separate upper cover (2) and lower cover (3), then remove
* : Standard screw
** : Tapping screw
6) Remove combination switch/contact coil and combination
7) If equipped with air bag system, disconnect connector from air
8) Disconnect horn connector from instrument panel harness.
3
9) Remove combination switch/contact coil and combination
INSPECTION
1 For vehicle with air bag system:
Check contact coil harness (1) for any signs of scorching, melting
or other damage. If it is damaged, replace.
INSTALLATION
1) Check to make sure that vehicle's front tires are set at straight-
2) Connect all connectors disconnected in REMOVAL.
COLUMN in this section.
them.
switch assembly screws (1) and disconnect connectors (2) from
combination switch.
bag harness.
switch assembly (3) from steering column.
ahead position and then ignition switch is at "LOCK" position.
STEERING WHEEL AND COLUMN 3C-9