Suzuki RA410 Manual page 706

2
Condition between diagnosis switch terminal
and body ground
DIAGNOSTIC TROUBLE CODE (DTC) CHECK
1) Check that malfunction indicator lamp (1) comes ON when igni-
tion switch is turned ON.
If it does not come ON, proceed to TABLE B.
2) Using service wire, ground diagnosis switch terminal (3) in "AIR
BAG" monitor coupler (2).
3) Read DTC from flashing pattern of malfunction indicator lamp
(1). (Refer to DIAGNOSTIC TROUBLE CODE (DTC) TABLE.)
If it cannot indicate flashing pattern of DTC, proceed to TABLE
D .
4) After completing the check, turn ignition switch to OFF position
1
and disconnect service wire from "AIR BAG" monitor coupler.
2
3
DIAGNOSTIC TROUBLE CODE (DTC)
CLEARANCE
1) Turn ignition switch ON and wait about 6 seconds or more.
2) Using service wire, repeat shorting and opening between diag-
nosis switch terminal on "AIR BAG" monitor coupler and body
ground 5 times at about 1 second intervals.
3) Wait about 9 seconds or more with opening between diagnosis
switch terminal and body ground.
4) Perform DTC Check and confirm that normal DTC (DTC 12) is
displayed and not malfunction DTC.
NOTE:
If DTC 51, DTC 53 or DTC 71 is stored in SDM, it is not possible
to clear DTC.
AIR BAG SYSTEM 10B-11