Suzuki RA410 Manual page 226

5-22 BRAKES
(a)
2
1
5) Calk spindle nut (1) as shown.
6) Install spindle cap.
NOTE:
When installing spindle cap, hammer lightly several loca-
tions on the collar of cap until collar comes closely into con-
tact with brake durm.
If fitting part of cap is deformed or damaged or if it is fitted
loosely, replace with new one.
7) Tighten wheel nuts to specified torque.
Tightening Torque
(a): 85 N m (8.5 kg-m, 61.5 lb-ft)
8) Upon completion of all jobs, depress brake pedal with about 20
– 30 kg load three to five times so as to obtain proper drum-to-
shoe clearance. Adjust parking brake cable.
9) Check to make sure that brake drum is free of dragging and
brake works properly. Then remove vehicle from lift and perform
brake test.
BRAKE SHOE
REMOVAL
1) Remove brake drum, referring to BRAKE DRUM REMOVAL.
2) Remove shoe hold down springs (1) by turning shoe hold down
pins (2).
3) Remove return springs, brake shoes and strut.
4) Disconnect parking brake shoe lever (1) from parking brake
cable (2).