Suzuki RA410 Manual page 198

4A-6 FRONT DRIVE SHAFT
3
3
For DOJ type drive shaft (Left side)
1) Remove boot band (1) of differential side joint.
2) Slide boot (1) toward the center of shaft and remove snap ring
(2) from outer race, then take shaft out of outer race (3).
3) Wipe off grease and remove circlip (1) used to fix cage by using
special tool (A).
Special Tool
(A): 09900-06107
4) Draw away cage (1) by using bearing puller (2), and remove
boot (3) from shaft.
NOTE:
Do not disassemble wheel side joint (outboard joint). If any
malcondition is found in any joint, replace it as assembly.
INSPECTION
Inspect boots for breakage or deterioration.
Replace them as necessary.
Inspect circlip, snap ring and boot bands for breakage or de-
formation. Replace as necessary.