Oil Pressure Check - Suzuki RA410 Manual

2
1
1. Full level mark (hole)
2. Low level mark (hole)
1

OIL PRESSURE CHECK

NOTE:
Prior to checking oil pressure, check the following items.
Oil level in oil pan.
If oil level is low, add oil up to Full level mark (hole) on oil
level gauge.
Oil quality.
If oil is discolored, or deteriorated, change it.
For particular oil to be used, refer to the table in Section 0B.
Oil leaks.
If leak is found, repair it.
1) Remove front bumper (refer to Section 9) and oil pressure
switch (1) from cylinder block.
2) Install special tool (Oil pressure gauge) to vacated threaded
hole.
Special Tool
(A): 09915-77310
(B): 09915-78211
3) Start engine and warm it up to normal operating temperature.
NOTE:
Be sure to place transmission gear shift lever in "Neutral"
(shift select lever to "P" range for A/T model), and set park-
ing brake and block drive wheels.
4) After warming up, raise engine speed to 4,000 r/min and mea-
sure oil pressure.
Oil pressure specification:
330 – 430 kPa (3.3 – 4.3 kg/cm
r/min (rpm)
5) Stop engine and remove oil pressure gauge.
ENGINE MECHANICAL 6A4-7
2
, 46.9 – 61.1 psi) at 4,000