Suzuki RA410 Manual page 562

3
2
1
1, (a)
DISMOUNTING
1) Take down engine with transmission (Refer to Section 6A4).
2) Remove torque converter housing lower plate.
3) Remove drive plate bolts (1).
To lock drive plate (2), engage a proper size rod (3) with the drive
plate gear.
4) Remove starter motor.
5) Remove bolts and nuts fastening engine and transmission, and
remove transmission from engine. (Refer to Section 6A4.)
NOTE:
When removing transmission from engine, move it in paral-
lel with crankshaft and use care so as not to apply exces-
sive force to drive plate and torque converter.
WARNING:
Be sure to keep transmission with torque converter hori-
zontal or facing up throughout the work. Should it be
tilted with torque converter down, converter may fall off
and cause personal injury.
REMOUNTING
Reverse dismounting procedure.
The important steps in installation are as follows.
Tighten drive plate bolts (1) to specified torque.
Tightening Torque
.
(a): 20 N m (2.0 kg-m, 14.5 lb-ft)
Tighten starting motor mounting bolts.
Remount engine with transmission according to procedure de-
scribed in Section 6A4.
Set each clamp for wiring securely.
Adjust select cable.
Refill fluid and adjust its level at normal operating temperature.
Check to confirm engine and transmission function acceptably.
Make sure that there is no evidence of fluid leakage.
AUTOMATIC TRANSMISSION 7B-35