Air Bag System - Suzuki RA410 Manual

WARNING:
Service on or around the air bag system components or wiring must be performed only by an au-
thorized SUZUKI dealer. Please observe all WARNINGS and "Service Precautions" under "On-Ve-
hicle Service" in this section before performing service on or around the air bag system
components or wiring. Failure to follow WARNINGS could result in unintentional activation of the
system or could render the system inoperative. Either of these two conditions may result in severe
injury.
The procedures in this section must be followed in the order listed to disable the air bag system
temporarily and prevent false diagnostic trouble codes from setting. Failure to follow procedures
could result in possible activation of the air bag system, personal injury or otherwise unneeded
air bag system repairs.
CAUTION:
When fasteners are removed, always reinstall them at the same location from which they were re-
moved. If a fastener needs to be replaced, use the correct part number fastener for that application.
If the correct part number fastener is not available, a fastener of equal size and strength (or stronger)
may be used. Fasteners that are not reused, and those requiring thread-locking compound, will be
called out. The correct torque value must be used when installing fasteners that require it. If the
above conditions are not followed, parts or system damage could result.
GENERAL DESCRIPTION
Operation of air bag system
at collision . . . . . . . . . . . . . . . . . . . . . . . . . . .
System components and wiring
location view and connectors
System wiring diagram
DIAGNOSIS . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Diagnostic trouble codes
Use of special tools
Intermittents and poor connections
Air bag diagnostic system check
Diagnostic trouble code (DTC) check
Diagnostic trouble code (DTC)
clearance . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Diagnostic trouble code (DTC) table
Table A - "AIR BAG" warning lamp
comes ON steady without flashing
Table B - "AIR BAG" warning lamp
does not come ON
SECTION 10B

AIR BAG SYSTEM

. . . . . . . . . . . . . . . . 10B- 3
10B- 3
. . . . . . . . . . . 10B- 4
. . . . . . . . . . . . . . . . . 10B- 5
10B- 6
. . . . . . . . . . . . . . . . 10B- 6
. . . . . . . . . . . . . . . . . . . . 10B- 6
. . . . . . . 10B- 8
. . . . . . . . . 10B- 9
. . . . . 10B-11
10B-11
. . . . . . 10B-12
. . . . . . 10B-14
. . . . . . . . . . . . . . . . . . . . 10B-14
CONTENTS
Table C - "AIR BAG" warning lamp
flashes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table D - "AIR BAG" warning lamp
cannot indicate DTC by flashing
DTC 15 - Passenger air bag initiator
circuit resistance high
DTC 16 - Passenger air bag initiator
circuit resistance low
DTC 18 - Passenger air bag initiator
circuit short to ground
DTC 19 - Passenger air bag initiator
circuit short to power circuit
DTC 21 - Driver air bag initiator
circuit resistance high
DTC 22 - Driver air bag initiator
circuit resistance low
DTC 24 - Driver air bag initiator
circuit short to ground
AIR BAG SYSTEM 10B-1
10B-14
. . . . . . . . 10B-14
. . . . . . . . . . . . . . . . . 10B-20
. . . . . . . . . . . . . . . . . . 10B-20
. . . . . . . . . . . . . . . . . 10B-20
. . . . . . . . . . . . 10B-20
. . . . . . . . . . . . . . . . . 10B-25
. . . . . . . . . . . . . . . . . . 10B-25
. . . . . . . . . . . . . . . . . 10B-25
10B