Suzuki RA410 Manual page 597

7B-70 AUTOMATIC TRANSMISSION
2
31) Install race incorporated type bearings (1) to both front and rear
sides of sun gear input drum (2).
NOTE:
To facilitate installation of bearing, apply grease (SUZUKI
SUPER GREASE C: 99000-25030) to internal gear side of
bearing.
32) Install sun gear input drum (1) to direct clutch drum (2) by
matching their splines.
33) Set assembled clutch assembly in case.
CAUTION:
Check bearing of sun gear input drum and seal ring (1)
of output shaft for proper assembling and install them.
34) Remove sealant from anchor end bolt (1) and set it in case.
35) Set brake band (1) so that it becomes flush with direct clutch
drum by means of anchor end bolt and servo stem and tighten
anchor end bolt temporarily.