Suzuki RA410 Manual page 753

10B-58 AIR BAG SYSTEM
For Driver Air Bag (Inflator) Module
3
For Passenger Air Bag (Inflator) Module
3
For Seat Belt Pretensioner
(A)
1
3
10) Connect (2) the air bag (inflator) module or seat belt preten-
11) Notify all people in the immediate area that you intend to
2
6) Stretch the deployment harness from the driver or passenger
air bag (inflator) module to its full length 10 m (33 ft) (1).
Special Tool
(A): 09932-75030
7) Place a power source (3) near the shorted end of the deploy-
ment harness. Recommended application: 12 Volts minimum,
2 amps minimum. A vehicle battery is suggested.
8) Verify that the area around the air bag (inflator) module or seat
belt pretensioner is clear of all people and loose or flammable
objects.
9) [In case of Driver Air Bag (Inflater) Module]
Verify that the driver air bag (inflator) module is resting with its
vinyl trim cover facing up.
[In case of Passenger Air Bag (Inflator) Module]
Verify that the passenger air bag (inflator) module is firmly and
properly secured in passenger air bag (inflator) module de-
ployment fixture (special tool).
[In case of Seat Belt Pretensioner]
Verify that the seat belt pretensioner, is placed as shown in the
figure on the ground in the space just cleared.
sioner to the deployment harness connector and lock connec-
tor with lock lever.
deploy/activate the air bag (inflator) module or seat belt pre-
tensioner.
NOTE:
When the air bag deploys and the pretensioner acti-
vates, the rapid gas expansion will create a substantial
report. Wear suitable ear protection. Notify all people in
the immediate area that you intend to deploy the air bag
(inflator) module or activate the seat belt pretensioner
and suitable ear protection should be worn.
When the driver air bag deploys and the pretensioner
activates, driver air bag (inflator) module and preten-
sioner (retractor assembly) may jump about 30 cm (1 ft)
vertically. This is a normal reaction of them to the force
of the rapid gas expansion inside the air bag and pre-
tensioner.
After the air bag (inflator) module has been deployed,
the surface of the air bag may contain a powdery resi-
due. This powder consists primarily of cornstarch
(used to lubricate the bag as it inflates) and byproducts
of the chemical reaction.