Bump Stopper - Suzuki RA410 Manual

3E-8 REAR SUSPENSION
2, (a)
1
2, (a)
1
1, (a)
2, (b)
2
1
7) Install wheel (1) and tighten wheel nuts (2) to specified torque.
Tightening Torque
(a): 85 N·m (8.5 kg-m, 61.5 lb-ft)
8) Lower hoist and vehicle in non-loaded condition, tighten ab-
sorber lower nut (1) and lateral rod right side nut (2) to specified
torque.
Tightening Torque
(a): 25 N·m (2.5 kg-m, 18.5 lb-ft)
(b): 65 N·m (6.5 kg-m, 47.0 lb-ft)

BUMP STOPPER

REMOVAL
1) Hoist vehicle and remove rear wheel.
2) Remove bump stopper using flat tip screwdriver.
INSTALLATION
1) Install bumper stopper.
NOTE:
Before installing bushing, apply soap water on it.
2) Install wheel (1) and tighten wheel nuts (2) to specified torque.
Tightening Torque
(a): 85 N·m (8.5 kg-m, 61.5 lb-ft)