Suzuki RA410 Manual page 462

6G-6 CRANKING SYSTEM
3
1
2
ON-VEHICLE SERVICE
For overhauling of starting motor, it is recommended that compo-
nent parts should be cleaned thoroughly. However, yoke, armature
coil, over-running clutch, magnetic switch assembly, rubber or
plastic parts are NOT ALLOWED to be washed in degreasing tank
or with grease dissolving solvent. Those parts should be cleaned
by blowing air and wiping with cloth.
DISMOUNTING AND REMOUNTING
1
1) Disconnect postitive ( + ) and negative ( – ) battery lead cables
at battery.
2) Remove battery and battery tray.
3) Disconnect battery cable and magnetic switch lead wire (1)
from starting motor terminals.
4) Remove 2 starting motor mounting bolts (2).
5) Remove starting motor (3).
2
6) To install, reverse the above procedure.
DISASSEMBLY
NOTE:
Before disassembling starting motor, be sure to put match
marks at two locations (A and B) as shown in left figure so that
any possible mistakes can be avoided.
1) Remove nut (1) securing the end of field coil lead to terminal on
the head of magnetic switch.
2) Take off magnetic switch (1) from starting motor body by remov-
1 ing two mounting screws (2).