Toshiba TX03 Series Manual page 87

6.6.3 STOP mode
Except some peripheral circuits, all the internal circuits including the internal oscillator are brought to a
stop in STOP mode.
When releasing STOP mode, the operation mode changes to the operation mode before entering STOP mode.
The STOP mode enables to select the pin status by setting the CGSTBYCR<DRVE>. Table 6-4 shows the
pin status in the STOP mode.
Note: Warm-up is need at the time of a return. It is necessary to set warm-up time in the mode (NORMAL
mode or SLOW mode) before entering STOP mode. Please refer to "6.6.8 Clock Operations in
Mode Transition"
Table 6-4 Pin States in the STOP mode
Function
X1, XT1
Oscillator
X2, XT2
PORT Px
TMS/SWDIO
Debug
TDO/SWV
Interrupt INT
SSP SPCLK, SPFSS, SPDO
except
above
ο : Valid input or output.
× : Invalid input or output.
Note: x: port number / m: corresponding bit
about warm-up time.
Pin Name I/O
Input
Output
Input
Output
Input
Output
Input
Output
Input
Output
Page 65
<DRVE> = 0 <DRVE> = 1
×
"High" level output. "High" level output.
× Depends on PxIE[m]
× Depends on PxCR[m]
Depends on PxIE[m]
Depend on PxCR[m]
and enable when data is valid
Depends on PxIE[m]
Depend on PxCR[m]
×
and enable when data is
valid
× Depends on PxIE[m]
× Depend on PxCR[m]
TMPM3V6/M3V4
×
2019-02-06