Replacing The Compactflash Card - Siemens SIMOTION D410 Series Commissioning Manual

3. Check the position of the fan cables to ensure that they do not become jammed when the
4. Replace the plastic enclosure and re-engage all 7 snap hooks.
5.2.4

Replacing the CompactFlash card

If spare parts are being used, you must seek the assistance of the Technical Support Center
in order to convert the license key code of the defective CompactFlash Card to that of the
new CompactFlash Card.
Proceed as follows to write your project to the new CompactFlash Card:
● Change the CompactFlash card; for information, refer to the section titled Replacing the
● Write to the CompactFlash card; for information, refer to the section titled Writing to a
Detailed information on the subject of licensing can be found in the
Configuration Manual.
D410
Commissioning Manual, 05/2009
plastic enclosure is replaced.
CompactFlash Card (Page 165).
CompactFlash card (Page 166).
Maintenance and service
5.2 Replacing modules (spare part scenario)
SIMOTION SCOUT
149