Installing A License Card; Replacing The Cpu Card; Usb To 25 Way D Type Adaptor - Siemens Stratos Outstation General, Installation, Commissioning & Maintenance Handbook

4.4.3

Installing a License Card

Should a License card need to be installed / replaced the following procedure should be
followed:
1. Power down the Stratos Outstation.
2. Unplug connectors and slide the unit free of any rack so that the bottom edge of the
CPU board can be accessed.
3. Turn the circular metal locking ring with a finger to unlock the holder.
4. Lift the bottom edge of the card holder.
5. Insert the card in to the holder as shown – contact side towards board and chamfered
edge towards bottom of board.
6. Lower the holder and return the locking ring to the locked position.
For License installation see the User Interface Handbook 667/HU/46000/000.
4.4.4

Replacing the CPU card

Should the CPU card need to be replaced, see section 7.3.1 for details.
4.5

USB to 25 Way D Type Adaptor

A USB to 25W D type handset adaptor is available (667/1/47180/000), which allow
connection from legacy 25 way handset terminals to the Outstation command line
interface via the 2 USB host connections on the front of the CPU board. The cable comes
with two USB connectors; these must be both connected to provide power and
communications to the legacy handset device. The supported handset baud rates are
19200, 9600 and 1200 (all 7 data, even parity, auto baud). To reset the auto baud rate
detection, the USB connectors need to be disconnected and reconnected.
Security classification Unrestricted
Version 3
Last Editor Alan Doyle
Document Name Stratos Outstation General and ICM Handbook
Copyright © Siemens plc 2014. All Rights Reserved.
Mobility, Intelligent Traffic Systems
Sopers Lane, Poole, Dorset, BH17 7ER
Page
Status
Date
Document No.
Mobility and Logistics is a division of Siemens Plc
32 of 92
Issued
05-Oct-2017
667/HB/52250/000