Formatting The Compactflash Card; Bootloader On The Compactflash Card - Siemens SIMOTION D410 Series Commissioning Manual

5.5.3

Formatting the CompactFlash Card

You can format a faulty CompactFlash Card, for example. Proceed as follows:
1. Insert the CompactFlash Card into a CompactFlash Card adapter which is connected to
2. Format the CompactFlash Card in Windows (FAT or FAT16 file system).
3. If the CompactFlash Card bootloader is also defective, you will have to rewrite it.
See also
Bootloader on the CompactFlash card (Page 167)
5.5.4

Bootloader on the CompactFlash card

Writing a bootloader
A bootloader may need to be written in the following situations:
● When a new bootloader is required for the SIMOTION D410 firmware version being used.
● When a new bootloader is required for the used SIMOTION D410 hardware version.
● When the bootloader is defective.
The bootloader version can be fetched using SIMOTION SCOUT device diagnostics. If this
is not possible because of the following reason, this can be caused by an incorrect
bootloader version.
A potential fault description could be as follows:
The SIMOTION D410 does not power up, the RDY LED flashes red at 0.5 Hz and the
RUN/STOP LED lights up red, or all the LEDs remain off.
In this case, replace the bootloader version with the current version.
Use the "Options > Write boot sector..." function to write the bootloader version in
SIMOTION SCOUT to the CompactFlash Card.
Note
You require programming device/PC administrator rights in order to write to the boot sector.
If you do not have administrator rights on your programming device/PC, an administrator can
enter an administrator login for you in order to use this function, under "Options" > "Settings"
> "Rights".
Detailed information on the CompactFlash Card, bootloader version, SIMOTION D410
hardware, and SIMOTION firmware version compatibility relationships can be found in the
software compatibility list. This list is available both in the documentation supplied on the
SIMOTION SCOUT DVD (at \1_Important\German\Kompatibilität\) . . and on the Internet at
Internet address (http://support.automation.siemens.com/WW/view/en/18857317).
D410
Commissioning Manual, 05/2009
your programming device / PC.
The CompactFlash Card is formatted.
NOTICE
The CompactFlash Card must only be formatted with FAT or FAT16, and must not be
formatted with FAT32 or NTFS.
Maintenance and service
5.5 SIMOTION CompactFlash Card
167