Deleting User Data From The Compactflash Card - Siemens SIMOTION D410 Series Commissioning Manual

4. Wait until the D410 has completed the memory reset (RUN/STOP LED permanently lights
5. Now set the mode selector switch back to the required operating mode; for example, set
4.14.3

Deleting user data from the CompactFlash Card

Overview
You can delete the user data using SIMOTION SCOUT. SIMOTION D410 must be operating
in online mode. This deletes the following data:
● User data from the "volatile data" area
● Non-volatile data, with the exception of IP and DP parameters
● User data on the CompactFlash Card (user folders), including the SINAMICS
You can still go online to SIMOTION D410 at your programming device / PC. All licenses on
the CompactFlash Card are retained.
Deleting user data
1. Open the project you want to edit in SIMOTION SCOUT.
2. Go online to SIMOTION D410.
3. Select SIMOTION D410 in the Project Navigator, and then select the "Delete user data
4. Confirm the "Delete user data from card" message with "OK".
D410
Commissioning Manual, 05/2009
up yellow).
switches S1, S2, and S3 to ON for RUN mode.
Note
Memory reset is cancelled if you do not return the DIL switch to MRES as specified within
three seconds. Repeat the procedure in this case.
NOTICE
Please note that, during startup, the MRES setting will cause the factory settings to be
restored. For details, refer to the section titled Restoring the default settings of
SIMOTION D410 (Page 134).
Make sure you do not accidentally switch the power supply OFF/ON while MRES is set,
as this will re-establish the factory settings instead of performing a memory reset.
configuration data
on card" option from the "Target system" menu.
The user data are deleted. SINAMICS Integrated goes into offline mode.
Commissioning (software)
4.14 Deleting data
133