Siemens SIMOTION D410 Series Commissioning Manual page 40

Configuring SIMOTION D410
3.2 Inserting SIMOTION D410 into a project
Communication with the programming device / PC via PROFIBUS (only for D410 DP)
1. Select the PROFIBUS interface from the "Properties - PROFIBUS/MPI" dialog box and
2. The connection to the programming device / PC is activated automatically and HW Config
Note
The active state setting of the connection to the programming device / PC is only
visualized in NetPro!
Interconnection with the programming device / PC on PROFINET (only for D410 DN)
The "Properties - Ethernet Interface" dialog box is open.
Figure 3-1
Program the following parameters in the "Properties - Ethernet Interface" dialog box:
1. Click "New".
2. Select the new Ethernet subnet which is now displayed in the "Properties - Ethernet
3. Define your addresses in the "IP address" and "Subnet mask" fields of the "Properties -
40
confirm your selection with "OK".
opens.
Properties of the Ethernet interface
The "New Subnet Industrial Ethernet" dialog box opens. Rename the new subnet, or
accept the default name by clicking "OK".
Interface" dialog box.
Ethernet Interface" dialog box. Change to the "Network node" field and define whether
you are going to use a router and, if yes, enter the router address. Confirm with "OK".
D410
Commissioning Manual, 05/2009