Siemens SIMOTION D410 Series Commissioning Manual page 152

Maintenance and service
5.3 Adapting a project (new device type/device version)
3. Move the new module to the top field of the module rack using drag-and-drop.
Figure 5-3 HW Config module replacement
4. Confirm the dialog box that appears with "Yes" if you want to replace the
5. Accept the changes made to the hardware configuration with "Station" > "Save and
6. Close HW Config.
Note
The data for the SIMOTION device is immediately accepted into the SIMOTION SCOUT
project, and the entire project is saved. In this way, the project also accepts all changes in
the project (e.g. axis configuration).
If you are using technology packages in your project, these will also need to be updated.
If the module hardware changes (e.g. the D410 DP is replaced with the D410 PN), proceed
as described in the section titled Removing and replacing the SIMOTION D410 (Page 143).
152
SIMOTION device. The module is replaced.
Compile".
D410
Commissioning Manual, 05/2009