Upgrading The Compactflash Card's Bootloader; Downloading The Project To The Target System - Siemens SIMOTION D410 Series Commissioning Manual

Maintenance and service
5.3 Adapting a project (new device type/device version)
Additional references
For additional information, refer to the
5.3.7

Upgrading the CompactFlash Card's bootloader

Upgrading the D410 may also make it necessary to upgrade the bootloader of the
CompactFlash card.
Detailed information on the CompactFlash Card, bootloader version, SIMOTION D410
hardware, and SIMOTION firmware version compatibility relationships can be found in the
software compatibility list. This list is available both in the documentation supplied on the
SIMOTION SCOUT DVD (at \1_Important\German\Kompatibilität\) . . and on the Internet at
Internet address (http://support.automation.siemens.com/WW/view/en/18857317).
See also
Bootloader on the CompactFlash card (Page 167)
5.3.8

Downloading the project to the target system

Once all the changes required for upgrading your project have been made, you must
download the project to the SIMOTION D410.
Prerequisite
The firmware required is located on the CompactFlash Card; for information, refer to the
section titled Firmware update using a CompactFlash Card (Page 158).
Procedure
1. Save and compile the project.
2. Click "Connect with target system" to go online to the target system.
3. Execute the "Download to target system" command, and then select "Copy RAM to ROM"
4. For the automatic subsequent configuring in the SINAMICS Integrated drive, you must
5. Save the project.
156
to download the updated project to the CompactFlash Card as well.
now perform "Download to programming device".
SIMOTION SCOUT
Configuration Manual.
D410
Commissioning Manual, 05/2009