Siemens SIMOTION D410 Series Commissioning Manual page 164

Maintenance and service
5.4 Performing a firmware and project update
Upgrading with a CompactFlash Card
1. Switch the SIMOTION D410 to be upgraded off.
2. Insert the CompactFlash Card into the SIMOTION D410.
3. Switch the SIMOTION D410 back on. The D410 will begin to process the upgrade data.
4. Switch the D410 off and on again to perform a restart.
Downgrading
If the upgrade was not successful (the machine is not behaving as required, for example),
it is possible to undo the upgrade. To do this, proceed as follows:
1. Switch off the SIMOTION D410.
2. Set the service selector switch (switch 6) to ON.
Figure 5-5
3. Switch the SIMOTION D410 back on.
4. Set the service selector switch (switch 6) to OFF.
Additional references
Detailed information on upgrading devices can be found in the
Devices
164
The RDY LED will flash green during this process. Once the upgrade process is
complete, the RDY LED will change
– To green (constant) if the process was successful
– To red (constant) if the process was not successful
Switch position for downgrading
The system restores the data that were backed up during the upgrade process (TP,
project, user data). The data from the upgrade process are deleted.
The SIMOTION device restarts once this is complete.
Following startup, the configuration from the state present prior to the upgrade becomes
active.
Operating Instructions.
Upgrading SIMOTION
Commissioning Manual, 05/2009
D410