Adapting A Project (New Device Type/Device Version); Overview - Siemens SIMOTION D410 Series Commissioning Manual

Maintenance and service

5.3 Adapting a project (new device type/device version)

5.3 Adapting a project (new device type/device version)
5.3.1

Overview

The project needs to be adapted if you want to replace the type (e.g. D410 DP with
D410 PN) or version of the SIMOTION device in your existing project. Carry out this
replacement in HW Config.
A SIMOTION D can only be replaced with another if the SINAMICS version involved is the
same or higher. It is not possible to downgrade to a lower SINAMICS version.
When upgrading your user project, you must follow the steps outlined below depending on
the type of upgrade you are carrying out:
1. Replace the SIMOTION device in HW Config; for information, refer to the section titled
2. Upgrade the device version of SINAMICS components; for information, refer to the
3. Upgrade the technology packages; for information, refer to the section titled Upgrading
4. Upgrade the libraries; for information, refer to the section titled Upgrade the libraries
5. Back up variables; for information, refer to the section titled Backing up variables
6. Back up the CompactFlash Card bootloader; for information, refer to the section titled
7. Download the project to the target system; for information, refer to the section titled
150
Replacing the SIMOTION device in HW Config (Page 151).
section titled Upgrading the device version of SINAMICS components (Page 153).
technology packages (Page 154).
(Page 155).
(Page 155).
Upgrading the CompactFlash Card's bootloader (Page 156).
Downloading the project to the target system (Page 156).
D410
Commissioning Manual, 05/2009