Toshiba TLCS-900/H1 Series Manual page 334

(3) 1-word Data Transfer
Check the <MST> by the INTSBI interrupt process after the 1-word data transfer is
completed, and determine whether the mode is a master or slave.
a.
When the <TRX> = "1" (Transmitter mode)
Implement the process to generate a stop condition (Refer to 3.15.6 (4)) and
terminate data transfer.
When the <LRB> is "0", the receiver is requests new data. When the next
transmitted data is 8 bits, write the transmitted data to SBIDBR. When the next
transmitted data is other than 8 bits, set the <BC2:0> <ACK> and write the
transmitted data to SBIDBR. After written the data, <PIN> becomes "1", a serial
clock pulse is generated for transferring a new 1-word of data from the SCL pin,
and then the 1-word data is transmitted. After the data is transmitted, an INTSBI
interrupt request occurs. The <PIN> becomes "0" and the SCL line is pulled down
to the Low-level. If the data to be transferred is more than one word in length,
repeat the procedure from the <LRB> checking above.
INTSBI interrupt
if MST = 0
Then shift to the process when slave mode
if TRX = 0
Then shift to the process when receiver mode.
if LRB = 0
Then shift to the process that generates stop condition.
SBICR1
SBIDBR
End of interrupt
Note: X: Don't care
SCL
Write to SBIDBR
SDA D7
<PIN>
INTSBI
interrupt request
Output from master
Output from slave
Figure 3.15.15 Example in which <BC2:0> = "000" and <ACK> = "1" in transmitter mode
If <MST> = "1" (Master Mode)
Check the <TRX> and determine whether the mode is a transmitter or receiver.
Check the <LRB>. When <LRB> is "1", a receiver does not request data.
7 6 5 4 3 2 1 0
← X X X X X X X X
← X X X X X X X X
1 2 3
D6 D5 D4
92CF30-332
Set the bit number of transmit and ACK.
Write the transmit data.
4 5 6
D3 D2 D1
TMP92CF30
7 8 9
D0 ACK
Acknowledge
signal from a
receiver
2009-06-12