Calculate:hold:variation - Agilent Technologies U3606B Programmer's Reference Manual

2 CALCulate Subsystem

CALCulate:HOLD:VARiation

CALCulate:HOLD:VARiation

Syntax
CALCulate:HOLD:VARiation <value>
This command sets the variation of the hold function. When the variation is
set to 0, data hold is enabled. Otherwise, refresh hold is enabled.
CALCulate:HOLD:VARiation?
This command returns a numeric value that represents the variation of the
hold function.
Parameter
value
Remarks
• The hold variation does not reset when calculation functions are enabled by
• The hold variation value is stored in the nonvolatile memory. It is not
Example
& CALC:HOLD:VAR 5
& CALC:HOLD:VAR?
$ +5.000000E+00
34
Item Type
Numeric
the CALCulate[:STATe] command, nor when the CALCulate:FUNCtion
command is sent with CALCulate:STATe set to ON.
affected by a power-on cycle, Factory Reset (*RST command), Instrument
Preset (SYSTem:PRESet command), or function change.
Range of values
0% to 100%
This command sets the hold variation to 5%.
This query returns the hold variation.
Default value
10%
U3606B Programmer's Reference