Initiate:continuous - Agilent Technologies U3606B Programmer's Reference Manual

5 INITiate Subsystem

INITiate:CONTinuous

INITiate:CONTinuous
Syntax
INITiate:CONTinuous {0|1|OFF|ON}
This command sets the state of the initiate continuous mode. If the state is set
to ON, the measurements will be in free run (continuous) mode and you can
just use the FETCh? command to acquire readings without triggering the
source multimeter.
• 0|OFF: Initiates triggering mode
• 1|ON: Initiates continuous mode
N O T E
INITiate:CONTinuous?
This query returns a boolean value that represents the initiate continuous
mode.
Parameter
continuous
122
Sending the
the state of the initiate continuous mode to
Item Type
Boolean
INITiate[:IMMediate]
Range of values
0|1|OFF|ON
and the command will set
READ?
.
OFF
Default value
1
U3606B Programmer's Reference