CALCulate:AVERage:MAXimum?
Syntax
CALCulate:AVERage:MAXimum?
This query returns a numeric value that represents the highest value recorded
since averaging was enabled.
Remarks
• This command returns the maximum value found, or "0" if there is no data
• The instrument clears the stored average data when averaging is enabled,
Example
& CALC:AVER:MAX?
$ +1.007900E+01
See also
"CALCulate:FUNCtion"
"CALCulate[:STATe]"
"SYSTem:PRESet"
"*RST"
U3606B Programmer's Reference
is available.
when the CALCulate:FUNCtion command is sent while
CALCulate:STATe is set to ON, after a power-on cycle, after a Factory
Reset (*RST command), an Instrument Preset (SYSTem:PRESet
command), or after a function change.
on page 23
on page 315
on page 342
This query returns the maximum value found.
on page 20
CALCulate Subsystem
CALCulate:AVERage:MAXimum?
2
27