Table of Contents
Advertisement
[SOURce:]VOLTage:LIMit
Syntax
[SOURce:]VOLTage:LIMit <value>[,<save>]
This command sets the over-voltage limit for the constant current output. If
the load effect exceeds the over-voltage limit setting, the instrument output
will be dropped down to meet the over-voltage limit setting.
[SOURce:]VOLTage:LIMit?
This query returns a numeric value that represents the over-voltage limit value
of the constant current output.
Parameter
value
save
[1]
Remarks
• If the over-voltage limit value is set to zero, the instrument output will be
• If the over-voltage limit value is set to a greater value than the over-voltage
• The [SOURce:]VOLTage:LIMit command is not applicable for
• If the <save> value is set to "1" or "ON", the limit value set will be stored to
U3606B Programmer's Reference
Item
Type
Numeric
Boolean
If the <save> value is omitted, the [SOURce:]VOLTage:LIMit command will not store the
limit value to the U3606B's nonvolatile memory.
dropped down to zero for limiting.
protection value, the over-voltage protection value will be adjusted to equal
the over-voltage limit value.
square-wave output, range S1S2 (autoranging), 4-wire resistance
measurements (Lo Ω).
the U3606B's nonvolatile memory.
Range of values
Range
Min
S1
0 V
S1m
0 V
S2
0 V
[1]
0|1|OFF|ON
SOURce Subsystem
[SOURce:]VOLTage:LIMit
Default value
Max
31.5 V
30 V
31.5 V
30 V
8.4 V
8 V
0
11
263
Advertisement
Table of Contents
