SYSTem:SMOoth:FLUCtuation
Syntax
SYSTem:SMOoth:FLUCtuation <value>
This command sets the fluctuation count of the smooth function.
SYSTem:SMOoth:FLUCtuation?
This command queries the fluctuation count setting of the smooth function
and returns the numeric fluctuation count value.
Parameter
Item
value
Remarks
• When the value of the fluctuation count is set to 0.0%, the fluctuation
• The smooth function state is stored in the nonvolatile memory. It is not
N O T E
U3606B Programmer's Reference
Type
Numeric
function of the smooth function is disabled.
affected by a power-on cycle, Factory Reset (*RST command), Instrument
Preset (SYSTem:PRESet command), or function change.
Input signal readings that are more than or less than the fluctuation count
of the previous signal will reset the smooth function. It is recommended
that the fluctuation count is enabled.
SYSTem:SMOoth:FLUCtuation
Range of values
0.0% to 9.9%
SYSTem Subsystem
Default value
1.0%
319
13